REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during telephone and GPS antenna assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative battery terminal | Memorize steering angle neutral point | Lane Control System | |
| Pre-collision System | |||
| Intelligent Clearance Sonar System*1 | |||
| Parking Assist Monitor System | | ||
| Panoramic View Monitor System | | ||
| Lighting System (w/ Automatic Headlight Beam Level Control System) | | ||
| Initialize back door lock | Power Door Lock Control System | | |
| Reset back door close position | Power Back Door System (w/ Outside Door Control Switch) | | |
| Removal/installation of the spiral cable with sensor sub-assembly |
| Parking assist monitor system | |
| Steering angle neutral point (Initialize panoramic view monitor system) | Panoramic view monitor system | | |
| Steering angle neutral point (Initialize intelligent clearance sonar system) | Intelligent clearance sonar system | |
*1: When performing learning using the Techstream.
Click here
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click here
PROCEDURE
1. REMOVE INSTRUMENT PANEL SAFETY PAD
Click here
2. REMOVE DEFROSTER NOZZLE ASSEMBLY
Click here
3. REMOVE TELEPHONE AND GPS ANTENNA ASSEMBLY WITH BRACKET
| (a) Remove the 2 screws. |
|
| (b) Disengage the 2 claws. |
|
(c) Disconnect the connector to remove the telephone and GPS antenna assembly with bracket.
4. REMOVE TELEPHONE AND GPS ANTENNA ASSEMBLY
(a) Disengage the 2 claws and 6 guides to remove the telephone and GPS antenna assembly as shown in the illustration.
| Remove in this Direction |
5. REMOVE TELEPHONE AND GPS ANTENNA BRACKET
Components
InstallationLexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Generator (for 180 A Type): Components
COMPONENTS ILLUSTRATION *A Type A *B Type B *1 GENERATOR ASSEMBLY *2 WIRE HARNESS CLAMP BRACKET *3 TERMINAL CAP *4 GENERATOR ASSEMBLY BRACKET N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *1 GENERATOR BRUSH HOLDER ASSEMBLY *2 GENERATOR ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Vacuum Switching Valve (for Acis): Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 1 VACUUM SWITCHING VALVE ASSEMBLY (for ACIS) (a) Install the No. 1 vacuum switching valve assembly (for ACIS) to the intake air surge tank assembly with the bolt. Torque: 9.0 N·m {92 kgf·cm, 80 in·lbf} (b) Connect the 2 vacuum hose sub-assemblies to the No. ...