Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: GPS Antenna Connection Malfunction(short) (B15C0,B15C1)

DESCRIPTION

These DTCs are stored when a malfunction occurs in the navigation antenna assembly.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

B15C0

GPS Antenna Connection Malfunction(short)

GPS Antenna Connection Malfunction (short)

  • Navigation antenna assembly
  • Antenna cord sub-assembly
  • Navigation ECU

B15C1

GPS Antenna Connection Malfunction(break)

GPS Antenna Connection Malfunction (break)

  • Navigation antenna assembly
  • Antenna cord sub-assembly
  • Navigation ECU

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.

PROCEDURE

1.

CHECK DTC

(a) Clear the DTCs.

Body Electrical > Navigation System > Clear DTCs

(b) Recheck for DTCs and check that no DTCs are output.

Body Electrical > Navigation System > Trouble Codes

OK:

No DTCs are output.

OK

USE SIMULATION METHOD TO CHECK

NG

2.

INSPECT ANTENNA CORD SUB-ASSEMBLY

(a) Remove the antenna cord sub-assembly.

w/ Rear No. 2 Seat: Click here

w/o Rear No. 2 Seat: Click here

(b) Measure the resistance according to the value(s) in the table below.

*a

Component without harness connected

(Antenna Cord Sub-assembly)

*a

Component without harness connected

(Antenna Cord Sub-assembly)

Standard Resistance:

Tester Connection

Condition

Specified Condition

A-3 - B-1

Always

Below 1 Ω

A-3a - B-1a

Always

Below 1 Ω

A-3 or B-1 - Body ground

Always

10 kΩ or higher

A-3a or B-1a - Body ground

Always

10 kΩ or higher

NG

REPLACE ANTENNA CORD SUB-ASSEMBLY

OK

3.

INSPECT NAVIGATION ANTENNA ASSEMBLY

(a) Remove the navigation antenna assembly.

Click here

(b) Inspect the navigation antenna assembly.

Click here

OK

REPLACE NAVIGATION ECU

NG

REPLACE NAVIGATION ANTENNA ASSEMBLY

    Navigation Processor Malfunction (B15AD)
    DESCRIPTION This DTC is stored when a malfunction occurs in the navigation ECU. DTC No. Detection Item DTC Detection Condition Trouble Area B15AD Navigation Processor Malfunction When ...

    Speed Signal Malfunction (B15C2)
    DESCRIPTION The navigation ECU receives a vehicle speed signal from the combination meter assembly and information from the navigation antenna assembly, and then adjusts the vehicle position on the ma ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Audio And Visual System (for 8 Inch Display): Operation Check
    OPERATION CHECK REMOTE TOUCH (REMOTE OPERATION CONTROLLER ASSEMBLY) SELF CHECK NOTICE: Before entering self-diagnostic mode, make sure there are no obstructions which may interfere with operation of the remote touch screen, and that the remote touch screen is not dirty. Do not touch the remote ...

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sfi System: Dtc Check / Clear
    DTC CHECK / CLEAR NOTICE: When the diagnosis system is changed from normal mode to check mode or vice versa, all DTCs and freeze frame data recorded in normal mode are cleared. Before changing modes, always check and make a note of DTCs and freeze frame data. HINT: DTCs which are stored in the EC ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2026 Copyright www.lexusrx.net
    0.0098