DESCRIPTION
These DTCs are stored when a malfunction occurs in the CAN communication circuit.
DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
---|---|---|---|
U0073 | Sending Malfunction (Navigation to APGS) | CAN bus connection error | CAN communication system |
U0100 | Engine ECU Communication | CAN reception error | CAN communication system |
U0129 | VSC(ECB)ECU Communication | CAN reception error | CAN communication system |
U0140 | Lost Communication with Body Control Module | CAN reception error | CAN communication system |
U0155 | Meter ECU Communication | CAN reception error | CAN communication system |
U0164 | Air Conditioner ECU Communication | CAN reception error | CAN communication system |
U0198 | Lost Communication with Telematic Control Module | CAN reception error | CAN communication system |
U023B | Lost Communication with Image Processing Module "B" | CAN reception error | CAN communication system |
U0265 | Lost Communication with Image Processing Sensor A | CAN reception error | CAN communication system |
U1110 | Clearance Sonar ECU Communication | CAN reception error | CAN communication system |
PROCEDURE
1. | CHECK DTC (CAN COMMUNICATION SYSTEM) |
(a) Clear the DTCs.
Body Electrical > Navigation System > Clear DTCs(b) Turn the engine switch off.
(c) Turn the engine switch on (IG) and wait for 30 seconds.
(d) Recheck for DTCs and check if the same DTC is output again.
Body Electrical > Navigation System > Trouble CodesOK:
No DTCs are output.
OK | USE SIMULATION METHOD TO CHECK |
NG | GO TO CAN COMMUNICATION SYSTEM |
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Park / Neutral Position Switch: Inspection
INSPECTION PROCEDURE 1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY (a) Measure the resistance according to the value(s) in the table below when the transmission control shaft lever is moved to each position. Standard Resistance: Tester Connection Condition Specified Condition 1 (RB ...
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Panoramic Moon Roof System: Terminals Of Ecu
TERMINALS OF ECU CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR ASSEMBLY) (a) Disconnect the U2 sliding roof ECU (sliding roof drive gear assembly) connector. (b) Measure the resistance and voltage according to the value(s) in the table below. HINT: Measure the values on the wire harness side with ...