DESCRIPTION
When each button displayed on the multi-display assembly is selected via remote touch screen operation, the remote touch screen generates vibration feedback according to communication between the remote touch and radio receiver assembly.
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Click here
PROCEDURE
1. | CHECK MULTI-DISPLAY ASSEMBLY CUSTOMIZE SETTING |
(a) Using the multi-display assembly customize setting screen, check that the remote touch screen vibration feedback reaction force setting is not set to "Off".
OK:
The remote touch screen vibration feedback reaction force setting is not set to "Off".
NG | ![]() | CUSTOMIZE SETTING |
|
2. | REMOTE TOUCH (REMOTE OPERATION CONTROLLER ASSEMBLY) SELF CHECK (CHECK VIBRATION FEEDBACK GENERATION CONDITION) |
(a) Enter self-diagnostic mode.
Click here
(b) Operate the remote touch screen laterally and check that the remote touch screen generates vibration feedback.
NOTICE:
Since the remote touch screen may recognize a pinch in/out or flick operation if operated with 2 fingers, always use 1 finger to operate the remote touch screen in self-diagnostic mode.
OK:
Remote touch screen generates vibration feedback.
NG | ![]() | REPLACE REMOTE TOUCH (REMOTE OPERATION CONTROLLER ASSEMBLY) |
|
3. | CHECK NAVIGATION ECU |
(a) Replace the navigation ECU with a new or known good one.
Click here
(b) Check the malfunction disappears.
OK:
Malfunction disappears.
OK | ![]() | END (NAVIGATION ECU IS DEFECTIVE) |
NG | ![]() | REPLACE RADIO RECEIVER ASSEMBLY |
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Rear Door: Components
COMPONENTS ILLUSTRATION *1 COURTESY LIGHT ASSEMBLY *2 REAR DOOR ARMREST COVER *3 REAR DOOR INNER GLASS WEATHERSTRIP *4 REAR DOOR INSIDE HANDLE BEZEL PLUG *5 REAR DOOR LOCK CONTROL KNOB BEZEL *6 REAR DOOR TRIM BOARD SUB-ASSEMBLY *7 REAR POWER WINDOW REGULATOR SWITC ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Steering Gear: Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE STEERING RACK BOOT CLIP (for LH Side) (a) Using pliers, remove the steering rack boot clip. 2. REMOVE STEERING RACK BOOT CLIP (for RH Side) HINT: Perform the same procedure as for the LH side. 3. REMOVE NO. 2 STEERING RACK BOOT CLAMP (for LH Side) (a) Using a screw ...