DESCRIPTION
The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the radio receiver assembly via this circuit.
WIRING DIAGRAM
PROCEDURE
| 1. | CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
(a) Disconnect the J148 radio receiver assembly connector.
(b) Disconnect the J152 No. 1 stereo jack adapter assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| J148-14 (ADPG) - J152-2 (ADPG) | Always | Below 1 Ω |
| J148-10 (AGND) - J152-7 (AGND) | Always | Below 1 Ω |
| J148-12 (VAR+) - J152-6 (VAR+) | Always | Below 1 Ω |
| J148-11 (VAL+) - J152-1 (VAL+) | Always | Below 1 Ω |
| J148-13 (VA-) - J152-5 (VA-) | Always | Below 1 Ω |
| J148-14 (ADPG) or J152-2 (ADPG) - Body ground | Always | 10 kΩ or higher |
| J148-10 (AGND) or J152-7 (AGND) - Body ground | Always | 10 kΩ or higher |
| J148-12 (VAR+) or J152-6 (VAR+) - Body ground | Always | 10 kΩ or higher |
| J148-11 (VAL+) or J152-1 (VAL+) - Body ground | Always | 10 kΩ or higher |
| J148-13 (VA-) or J152-5 (VA-) - Body ground | Always | 10 kΩ or higher |
| OK | | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
| NG | | REPAIR OR REPLACE HARNESS OR CONNECTOR |
Illumination Circuit
Speaker CircuitLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Vehicle Stability Control System: Stop Lamp Relay Actuator Stuck Off (C13807F)
DESCRIPTION Refer to DTC C13807E. Click here DTC No. Detection Item DTC Detection Condition Trouble Area C13807F Stop Lamp Relay Actuator Stuck Off Either of the following is detected:
When the IG1 terminal voltage exceeds 10 V and the +BS terminal voltage is from 9.5 to 17.4 V ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Washer Nozzle(for Front Side): Adjustment
ADJUSTMENT PROCEDURE 1. REMOVE WASHER NOZZLE SUB-ASSEMBLY Click here 2. ADJUST WASHER NOZZLE SUB-ASSEMBLY (a) Select a washer nozzle sub-assembly so that the position that the washer fluid hits the windshield will be within the standard area. Replace the washer nozzle sub-assembly with the selecte ...