DESCRIPTION
This DTC is stored when a beam axis adjustment has not been performed for the blind spot monitor sensor RH.
HINT:
This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that a beam axis adjustment is performed. Completing the beam axis adjustment after replacing a blind spot monitor sensor prevents this DTC from being output.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1ABC | Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete | A beam axis adjustment has not been performed | Blind spot monitor sensor RH |
PROCEDURE
| 1. | PERFORM BLIND SPOT MONITOR BEAM AXIS ADJUSTMENT |
(a) Perform the Blind Spot Monitor Beam Axis Adjustment using the Techstream.
Body Electrical > Blind Spot Monitor Slave > Utility| Tester Display |
|---|
| BSM Slave Beam Axis Adjustment |
HINT:
Refer to Blind Spot Monitor Beam Axis Confirmation.
Click here
| NEXT | | END |
Blind Spot Monitor Master Module Beam Axis Inspection Incomplete (C1ABB)
Short to +B in Buzzer (C1ABD,C1ABE)Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Rear Spoiler: Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE NO. 1 REAR SPOILER PROTECTOR (except TMMC Made) (a) Remove the 5 No. 1 rear spoiler protectors. 2. REMOVE NO. 2 REAR SPOILER PROTECTOR (except TMMC Made) (a) Remove the 3 No. 2 rear spoiler protectors. 3. REMOVE REAR SPOILER SEAL (a) R ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Automatic Transaxle System: Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the Techstream to read the Data List allows the values or states of ...