DESCRIPTION
This DTC is stored when a beam axis adjustment has not been performed for the blind spot monitor sensor LH.
HINT:
This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that a beam axis adjustment is performed. Completing the beam axis adjustment after replacing a blind spot monitor sensor prevents this DTC from being output.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1ABB | Blind Spot Monitor Master Module Beam Axis Inspection Incomplete | A beam axis adjustment has not been performed | Blind spot monitor sensor LH |
PROCEDURE
| 1. | PERFORM BLIND SPOT MONITOR BEAM AXIS ADJUSTMENT |
(a) Perform the Blind Spot Monitor Beam Axis Adjustment using the Techstream.
Body Electrical > Blind Spot Monitor Master > Utility| Tester Display |
|---|
| BSM Master Beam Axis Adjustment |
HINT:
Refer to Blind Spot Monitor Beam Axis Confirmation.
Click here
| NEXT | | END |
Blind Spot Monitor Slave Module (C1AB7)
Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete (C1ABC)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Audio And Visual System (for 12.3 Inch Display): Visual Mute Signal Circuit between Radio Receiver and Multi-display
DESCRIPTION The radio receiver assembly sends a visual mute signal to the multi-display assembly. As a result, a black screen is displayed when the screen changes so that noise and distorted images are not displayed. When an open exists in the circuit, noise and distorted images will be displayed in ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Back Door Drive Unit: Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL BACK DOOR DAMPER STAY LOWER BRACKET (a) Clean the bolt holes in the vehicle body. (b) Install the back door damper stay lower bra ...