DESCRIPTION
This DTC is stored when the blind spot monitor sensor RH detects an internal malfunction.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AB7 | Blind Spot Monitor Slave Module | The blind spot monitor sensor RH (slave) detects an internal malfunction | Blind spot monitor sensor RH |
CAUTION / NOTICE / HINT
NOTICE:
When checking for DTCs, make sure that the blind spot monitor system is turned on.
PROCEDURE
| 1. | CHECK DTC |
(a) Turn the engine switch off.
(b) Turn the engine switch on (IG).
(c) Recheck for DTCs and check if the same DTC is output again.
Body Electrical > Blind Spot Monitor Slave > Trouble CodesOK:
No DTCs are output.
| OK | | USE SIMULATION METHOD TO CHECK |
| NG | | REPLACE BLIND SPOT MONITOR SENSOR RH |
Blind Spot Monitor Master Module (C1AB6)
Blind Spot Monitor Master Module Beam Axis Inspection Incomplete (C1ABB)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Combination Meter: Components
COMPONENTS ILLUSTRATION *1 COMBINATION METER ASSEMBLY *2 COWL SIDE TRIM BOARD LH *3 FRONT DOOR SCUFF PLATE LH *4 HOOD LOCK CONTROL LEVER SUB-ASSEMBLY *5 INSTRUMENT CLUSTER FINISH PANEL ORNAMENT *6 INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY *7 INSTRUMENT PANEL GA ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Lighting System (w/o Automatic Headlight Beam Level Control System): Terminals Of Ecu
TERMINALS OF ECU CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (a) Disconnect the instrument panel junction block assembly and main body ECU (multiplex network body ECU) connectors. (b) Measure the voltage and resistance according to the value(s) in t ...