DESCRIPTION
This DTC is stored when the blind spot monitor sensor LH detects an internal malfunction.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AB6 | Blind Spot Monitor Master Module | The blind spot monitor sensor LH (master) detects an internal malfunction | Blind spot monitor sensor LH |
CAUTION / NOTICE / HINT
NOTICE:
When checking for DTCs, make sure that the blind spot monitor system is turned on.
PROCEDURE
| 1. | CHECK DTC |
(a) Turn the engine switch off.
(b) Turn the engine switch on (IG).
(c) Recheck for DTCs and check if the same DTC is output again.
Body Electrical > Blind Spot Monitor Master > Trouble CodesOK:
No DTCs are output.
| OK | | USE SIMULATION METHOD TO CHECK |
| NG | | REPLACE BLIND SPOT MONITOR SENSOR LH |
Open in Outer Mirror Indicator(Slave) (C1AB5)
Blind Spot Monitor Slave Module (C1AB7)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Steering System: PIG Power Supply Voltage (C1552,C1554)
DESCRIPTION If a problem occurs in the system, the power source relay circuit and the motor relay circuit are shut off to stop power assist. The ECU must be replaced when there is a problem with the relays because the relays are built into the ECU. DTC No. Detection Item DTC Detection Conditi ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Steering System: Terminals Of Ecu
TERMINALS OF ECU CHECK POWER STEERING ECU ASSEMBLY *a Component without harness connected (Power Steering ECU Assembly) - - (a) Measure the voltage and resistance according to the value(s) in the table below. NOTICE: When the EPS warning light is illuminated due to a malfunction, the fa ...