INSTALLATION
PROCEDURE
1. INSTALL NO. 2 CLEARANCE WARNING BUZZER
(a) Connect the connector.
(b) Engage the clamp to install the No. 2 clearance warning buzzer.
2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH
Click here
3. INSTALL RECLINING REMOTE CONTROL BEZEL RH (w/o Rear Power Seat System)
Click here
4. INSTALL FOLD SEAT SWITCH ASSEMBLY (w/ Rear Power Seat System)
Click here
5. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
Click here
6. INSTALL ROPE HOOK ASSEMBLY
HINT:
Use the same procedure as for the LH side.
Click here
7. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
Click here
8. INSTALL REAR FLOOR FINISH SIDE PLATE RH
HINT:
Use the same procedure as for the LH side.
Click here
9. INSTALL REAR SEAT SIDE GARNISH RH
HINT:
Use the same procedure as for the LH side.
Click here
10. INSTALL UPPER QUARTER TRIM PAD RH
HINT:
Use the same procedure as for the LH side.
Click here
11. INSTALL REAR SEAT ASSEMBLY RH
Click here
12. INSTALL REAR DOOR SCUFF PLATE RH
HINT:
Use the same procedure as for the LH side.
Click here
13. INSTALL REAR FLOOR FINISH PLATE
Click here
14. INSTALL DECK SIDE TRIM BOX RH
Click here
15. INSTALL REAR NO. 4 FLOOR BOARD
Click here
16. INSTALL REAR DECK FLOOR BOX
Click here
17. INSTALL REAR NO. 3 FLOOR BOARD
Click here
18. INSTALL DECK BOARD ASSEMBLY
Click here
19. INSTALL TONNEAU COVER ASSEMBLY
Click here
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Quarter Trim Speaker (w/ Rear No. 2 Seat): Inspection
INSPECTION PROCEDURE 1. INSPECT QUARTER SIDE SPEAKER ASSEMBLY (a) With the speaker installed, check that there is no looseness or other abnormalities. (b) Check that there is no foreign matter in the speaker, no tears on the speaker cone or other abnormalities. (c) Measure the resistance of the s ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Intelligent Clearance Sonar System: Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the Techstream to read the Data List allows the values or states of ...