DESCRIPTION
The rear corner ultrasonic sensor LH is installed to the rear bumper. The clearance warning ECU assembly detects obstacles based on signals received from the rear corner ultrasonic sensor LH. If the rear corner ultrasonic sensor LH has an open circuit or other malfunction, it will not function normally.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AE6 | Rear Left Sensor Malfunction | A malfunction of the rear corner ultrasonic sensor LH. |
|
CAUTION / NOTICE / HINT
NOTICE:
If DTCs are output after repairs, turn the engine switch on (IG) and the intuitive parking assist system on. Then clear the DTCs.
Click here
PROCEDURE
| 1. | CHECK DTC OUTPUT |
(a) Check for DTCs.
Click here
| Result | Proceed to |
|---|---|
| Only DTC C1AE6 is output | A |
| DTC C1AE6 and C1AED are output | B |
| No DTCs are output | C |
| B | | GO TO DTC (C1AED) |
| C | | USE SIMULATION METHOD TO CHECK |
|
| 2. | REPLACE REAR CORNER ULTRASONIC SENSOR LH |
(a) Replace the rear corner ultrasonic sensor LH with a known good one.
Click here
HINT:
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
|
| 3. | CHECK DTC OUTPUT |
(a) Clear the DTCs.
Click here
(b) Check for DTCs.
Click here
| Result | Proceed to |
|---|---|
| DTC C1AE6 is output | A |
| No DTCs are output | B |
| A | | REPLACE CLEARANCE WARNING ECU ASSEMBLY |
| B | | END (REAR LEFT SENSOR WAS DEFECTIVE) |
Front Right Sensor Malfunction (C1AE4)
Rear Left Center Sensor Malfunction (C1AE7)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Side Turn Signal Light Assembly: Inspection
INSPECTION PROCEDURE 1. INSPECT SIDE TURN SIGNAL LIGHT ASSEMBLY LH (a) Apply battery voltage to the side turn signal light assembly LH and check that the light comes on. OK: Condition Specified Condition Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 2 Side turn ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Automatic Transaxle System: Hydraulic Test
HYDRAULIC TEST PERFORM HYDRAULIC TEST (a) Measure the line pressure. CAUTION: A line pressure test should always be carried out with at least 2 people. One person should observe the condition of wheels and wheel chocks while the other is performing the test. NOTICE:
Perform this test with the ATF ...