DESCRIPTION
The rear center ultrasonic sensor LH is installed to the rear bumper. The clearance warning ECU assembly detects obstacles based on signals received from the rear center ultrasonic sensor LH. If the rear center ultrasonic sensor LH has an open circuit or other malfunction, it will not function normally.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AE7 | Rear Left Center Sensor Malfunction | A malfunction of the rear center ultrasonic sensor LH. |
|
CAUTION / NOTICE / HINT
NOTICE:
If DTCs are output after repairs, turn the engine switch on (IG) and the intuitive parking assist system on. Then clear the DTCs.
Click here
PROCEDURE
| 1. | CHECK DTC OUTPUT |
(a) Check for DTCs.
Click here
| Result | Proceed to |
|---|---|
| Only DTC C1AE7 is output | A |
| DTC C1AE7 and C1AED are output | B |
| No DTCs are output | C |
| B | | GO TO DTC (C1AED) |
| C | | USE SIMULATION METHOD TO CHECK |
|
| 2. | REPLACE REAR CENTER ULTRASONIC SENSOR LH |
(a) Replace the rear center ultrasonic sensor LH with a known good one.
Click here
HINT:
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
|
| 3. | CHECK DTC OUTPUT |
(a) Clear the DTCs.
Click here
(b) Check for DTCs.
Click here
| Result | Proceed to |
|---|---|
| DTC C1AE7 is output | A |
| No DTCs are output | B |
| A | | REPLACE CLEARANCE WARNING ECU ASSEMBLY |
| B | | END (REAR LEFT CENTER SENSOR WAS DEFECTIVE) |
Rear Left Sensor Malfunction (C1AE6)
Rear Right Center Sensor Malfunction (C1AE8)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Intake System: Parts Location
PARTS LOCATION ILLUSTRATION *1 INTAKE AIR CONTROL VALVE (for ACIS) *2 ECM *3 ENGINE ROOM RELAY BLOCK AND JUNCTION BLOCK ASSEMBLY - EFI NO. 2 FUSE - - ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Headup Display System: Freeze Frame Data
FREEZE FRAME DATA FREEZE FRAME DATA (a) Whenever a meter DTC is detected, the headup display (meter mirror sub-assembly) stores the current vehicle state as freeze frame data. CHECK FREEZE FRAME DATA (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream ...