DESCRIPTION
The rear center ultrasonic sensor RH is installed to the rear bumper. The clearance warning ECU assembly detects obstacles based on signals received from the rear center ultrasonic sensor RH. If the rear center ultrasonic sensor RH has an open circuit or other malfunction, it will not function normally.
DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
---|---|---|---|
C1AE8 | Rear Right Center Sensor Malfunction | A malfunction of the rear center ultrasonic sensor RH. |
|
CAUTION / NOTICE / HINT
NOTICE:
If DTCs are output after repairs, turn the engine switch on (IG) and the intuitive parking assist system on. Then clear the DTCs.
Click here
PROCEDURE
1. | CHECK DTC OUTPUT |
(a) Check for DTCs.
Click here
Result | Proceed to |
---|---|
Only DTC C1AE8 is output | A |
DTC C1AE8 and C1AED are output | B |
No DTCs are output | C |
B | ![]() | GO TO DTC (C1AED) |
C | ![]() | USE SIMULATION METHOD TO CHECK |
|
2. | REPLACE REAR CENTER ULTRASONIC SENSOR RH |
(a) Replace the rear center ultrasonic sensor RH with a known good one.
Click here
HINT:
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
|
3. | CHECK DTC OUTPUT |
(a) Clear the DTCs.
Click here
(b) Check for DTCs.
Click here
Result | Proceed to |
---|---|
DTC C1AE8 is output | A |
No DTCs are output | B |
A | ![]() | REPLACE CLEARANCE WARNING ECU ASSEMBLY |
B | ![]() | END (REAR RIGHT CENTER SENSOR WAS DEFECTIVE) |
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Lighting System (w/ Automatic Headlight Beam Level Control System): How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT:
Use the following procedure to troubleshoot the lighting system.
*: Use the Techstream.
PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP
NEXT 2. CUSTOMER PROBLEM ANALYSIS HINT:
In troubleshooting, confirm that the problem symptoms h ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Trip Switch: Installation
INSTALLATION PROCEDURE 1. INSTALL TRIP SWITCH (a) Engage the 2 claws as shown in the illustration to install the trip switch. Install in this Direction 2. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Click here 3. INSTALL LOWER INSTRUMENT FINISH PANEL SUB Click here 4. INSTAL ...