DESCRIPTION
These DTCs are stored if there is a malfunction in the CAN communication system connected to the rear television camera assembly.
HINT:
If CAN communication system DTCs are stored, they may also be stored in other systems.
DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
---|---|---|---|
U0100 | Lost Communication with ECM / PCM "A" | Lost Communication with ECM | CAN communication system |
U0126 | Lost Communication with Steering Angle Sensor Module | Lost communication with steering sensor | CAN communication system |
U0129 | Lost Communication with Brake System Control Module | Lost communication with skid control ECU | CAN communication system |
U0140 | Lost Communication with Body Control Module | Lost communication with main body ECU (multiplex network body ECU) | CAN communication system |
U0163 | Lost Communication with Navigation Control Module | Lost communication with radio receiver assembly | CAN communication system |
U0233 | Lost Communication with Blind Spot Monitor Master Module | Lost communication with blind spot monitor sensor LH | CAN communication system |
U1110 | Lost Communication with Intuitive Parking Assist Module | Lost communication with clearance warning ECU assembly | CAN communication system |
PROCEDURE
1. | CHECK DTC OUTPUT |
(a) Clear the DTCs.
Click here
(b) Recheck for DTCs and check that no DTCs are output.
Click here
HINT:
Click here
Result | Proceed to |
---|---|
DTCs are output | A |
No DTCs are output | B |
A | ![]() | GO TO CAN COMMUNICATION SYSTEM |
B | ![]() | USE SIMULATION METHOD TO CHECK |
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Active Control Engine Mount: Installation
INSTALLATION PROCEDURE 1. INSTALL FRONT ENGINE MOUNTING INSULATOR (a) Install the front engine mounting insulator to the front engine mounting bracket with the bolt. Torque: 87 N·m {887 kgf·cm, 64 ft·lbf} (b) Connect the vacuum hose to the No. 2 vacuum switching valve assembly. 2. INSTALL FRONT ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Panoramic View Monitor Switch: Installation
INSTALLATION PROCEDURE 1. INSTALL PANORAMIC VIEW MONITOR SWITCH (INTEGRATION CONTROL AND PANEL ASSEMBLY) (a) Engage the 4 claws to install the panoramic view monitor switch (integration control and panel assembly). 2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Click here 3. CONNECT ...