Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: CAN Communication Failure (Message Registry) (U1000)

NOTICE:

• When "!" mark is displayed on the multi-display assembly after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point.

  Click here

• Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

  Click here

HINT:

• If DTC U1000 is not output again when rechecking for DTCs, it may have been stored due to a temporary CAN malfunction.
• If DTC U1000 is output frequently, duplicate the problem symptoms and perform the inspection again, even if the DTC was not output when rechecking for DTCs.

  Click here

Lost Communication with ECM / PCM "A" (U0100,U0126,U0129,U0140,U0163,U0233,U1110)

DESCRIPTION These DTCs are stored if there is a malfunction in the CAN communication system connected to the rear television camera assembly. HINT: If CAN communication system DTCs are stored, they ma ...

Image from Camera for Parking Assist Monitor is Abnormal

DESCRIPTION The video signal from the rear television camera assembly is transmitted to the multi-display assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: When "!" mark is displayed on the ...

Other materials:

Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sfi System: Knock Sensor 1 Bank 1 or Single Sensor Circuit Short to Battery or Open (P032515,P033015)
DESCRIPTION Refer to DTC P032511. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P032515 Knock Sensor 1 Bank 1 or Single Sensor Circuit Short to Battery or Open The knock control sensor (bank 1) output voltage is higher than 4.5 V for ...

Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Panoramic View Monitor System: Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Chassis / Circumference Monitoring Camera Control Module / Trouble Codes. Chassis > Circumference Monitoring Camera Control Module > ...