REMOVAL
PROCEDURE
1. REMOVE REAR NO. 2 SEAT ASSEMBLY
Click here
2. REMOVE REAR DOOR SCUFF PLATE LH
Click here
3. REMOVE REAR DOOR INSIDE SCUFF PLATE LH
Click here
4. REMOVE REAR SEAT OUTER TRACK BRACKET COVER LH
for 60/40 Split Seat Type:
Click here
for Captain Seat Type:
Click here
5. REMOVE FRONT DECK SIDE TRIM COVER LH
Click here
6. REMOVE REAR SEAT SIDE GARNISH LH
Click here
7. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
Click here
8. REMOVE ROPE HOOK ASSEMBLY
Click here
9. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
Click here
10. REMOVE NO. 2 AIR CONDITIONING CONTROL ASSEMBLY
Click here
11. REMOVE COOLER (NO. 2 ROOM TEMP. SENSOR) THERMISTOR
Click here
12. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
Click here
13. REMOVE BLIND SPOT MONITOR BUZZER
(a) Disconnect the connector. |
|
(b) Disengage the clamp and remove the blind spot monitor buzzer.
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Differential Oil Seal (for Lh Side): Replacement
REPLACEMENT CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front drive shaft oil seal LH removal/installation are shown below. Necessary Procedures After Parts ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Automatic Transaxle System: Shift Solenoid "A" Circuit Short to Battery or Open (P075015)
DESCRIPTION Changing gears is performed by the ECM turning the shift solenoid valves SL1, SL2, SL3, SL4, SL5, S1 and S2 on and off. If an open or short occurs in any of the shift solenoid valve circuits, the ECM controls the remaining normal shift solenoid valves to allow the vehicle to be driven. I ...