PRECAUTION
PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
NOTICE:
When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following systems after the terminal is reconnected.
| System Name | See Procedure |
|---|---|
| Lane Control System | |
| Pre-collision System | |
| Intelligent Clearance Sonar System | |
| Parking Assist Monitor System | |
| Panoramic View Monitor System | |
| Lighting System (w/ Automatic Headlight Beam Level Control System) | |
| Power Door Lock Control System | |
| Power Back Door System (w/ Outside Door Control Switch) |
SERVICE MODE
NOTICE:
HINT:
When a warning is generated due to a vehicle malfunction, the DCM (Telematics Transceiver) receives warning information from the combination meter assembly and sends a warning notification to the service center.
(a) Service mode
(1) Enter service mode (Method 1)
(2) Enter service mode (Method 2)
Enter diagnostic mode of navigation system.
Click here
Enter diagnostic mode of audio and visual system.
for 12.3 Inch Display: Click here
for 8 Inch Display: Click here
HINT:
Use the Techstream to cancel communication function pausing mode (Service Mode).
Click here
PRECAUTION FOR TELEMATICS SYSTEM
(a) If replacing any of the following parts, refer to Initialization.
Click here
NOTICE:
If registration is not performed after replacing any of the following parts, the remote door lock and unlock and remote engine start and stop will not be available.
(1) Certification ECU (smart key ECU assembly)
(2) DCM (telematics transceiver)
(3) Main body ECU (multiplex network body ECU)
PRECAUTION FOR ACTIVATION
(a) When replacing the DCM (Telematics Transceiver), perform DCM activation.
Click here
PRECAUTION FOR TROUBLESHOOTING REMOTE SERVICE FUNCTION
(a) When troubleshooting symptoms such as when part of the remote service function does not operate normally, first check that there are no third party parts connected to the DLC3. If any such parts are connected to the DLC3, some parts of the remote service function may not operate normally.
Therefore, explain the situation to the customer, remove the parts and turn the engine switch off and on (IG) before proceeding with troubleshooting.
Parts LocationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sfi System: Vehicle Speed Sensor "A" No Signal (P050031)
DESCRIPTION Vehicles, which are equipped with ABS (Anti-lock Brake System), detect the vehicle speed using the skid control ECU (brake actuator assembly) and speed sensor. The speed sensor monitors the wheel rotation speed and sends a signal to the skid control ECU. The skid control ECU converts the ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Navigation System: Poor Sound Quality in All Modes (Low Volume)
PROCEDURE 1. CHECK AUDIO SETTINGS (a) Set treble, middle and bass to the initial values and check that the sound is normal. OK: The sound returns to normal. HINT: Sound quality adjustment measures vary according to the type of amplifier. OK END
NG 2. COMPARE ...