DESCRIPTION
Refer to DTC C050C1F.
Click here
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C050C3A | Left Rear Wheel Speed Sensor Signal Has Too Many Pulses | When not in Dealer Mode (Signal Check) or Inspection Mode, the output of the speed sensor detected by the skid control ECU (brake actuator assembly) is too high for 5 second or more. | Skid control ECU (brake actuator assembly) |
| C05123A | Right Rear Wheel Speed Sensor Signal Has Too Many Pulses | When not in Dealer Mode (Signal Check) or Inspection Mode, the output of the speed sensor detected by the skid control ECU (brake actuator assembly) is too high for 5 second or more. | Skid control ECU (brake actuator assembly) |
CAUTION / NOTICE / HINT
NOTICE:
After replacing the skid control ECU (brake actuator assembly), perform "Calibration".
Click here
PROCEDURE
| 1. | REPLACE BRAKE ACTUATOR ASSEMBLY |
(a) Replace the skid control ECU (brake actuator assembly).
Click here
| NEXT | | END |
Left Rear Wheel Speed Sensor Signal Stuck Low (C050C23)
Right Rear Wheel Speed Sensor Circuit Short to Battery (C051212)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Can Communication System: Suspension Control ECU Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Suspension Control ECU Communication Stop Mode Either condition is met:
"Suspension Control (Air Suspension)" is not displayed on the CAN Bus Check screen of the Techstream.
Click here
Communication system DTCs (DTCs that start w ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Parking Assist Ecu: Installation
INSTALLATION PROCEDURE 1. INSTALL PARKING ASSIST ECU (a) Install the parking assist ECU with the bolt and nut. (b) Connect each connector. 2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY Click here 3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Click here 4. INSTALL COWL SIDE TRIM BOARD R ...