INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL PARKING BRAKE ACTUATOR ASSEMBLY LH
(a) Apply a light coat of lithium soap base glycol grease to a new O-ring.
(b) Install the O-ring to the rear disc brake cylinder assembly LH.
NOTICE:
Make sure to replace the O-ring with a new one when installing the parking brake actuator assembly LH.
| (c) Using a 5 mm hexagon socket wrench, install the parking brake actuator assembly LH to the rear disc brake cylinder assembly LH with the 2 bolts. Torque: 8.4 N·m {86 kgf·cm, 74 in·lbf} |
|
2. CONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY
(a) Connect the No. 2 parking brake wire assembly connector to the parking brake actuator assembly LH.
3. INSTALL REAR WHEEL
Click here
Inspection
Electric Parking Brake SwitchLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Wireless Door Lock Control System: System Diagram
SYSTEM DIAGRAM Communication Table Sender Receiver Signal Line Certification ECU (Smart Key ECU Assembly) Main Body ECU (Multiplex Network Body ECU)
Wireless door lock/unlock signal
Wireless door lock buzzer sound request signal
CAN Main Body ECU (Multiplex Network ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Brake Actuator: On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. CONNECT TECHSTREAM (a) Connect the Techstream to the DLC3 with the engine switch off. (b) Start the engine and run it at idle. (c) Turn the Techstream on. (d) Enter the following menus: Chassis / Brake/EPB / Active Test. HINT: Refer to the Techstream operator's man ...