Components
COMPONENTS
ILLUSTRATION
| *1 | CONSOLE PANEL SUB-ASSEMBLY | *2 | ELECTRIC PARKING BRAKE SWITCH ASSEMBLY |
Inspection
INSPECTION
PROCEDURE
1. INSPECT ELECTRIC PARKING BRAKE SWITCH ASSEMBLY
(a) Check the resistance.
| (1) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the electric parking brake switch assembly. |
|
Removal
REMOVAL
PROCEDURE
1. PRECAUTION
Click here
2. REMOVE CONSOLE PANEL SUB-ASSEMBLY
Click here
3. REMOVE ELECTRIC PARKING BRAKE SWITCH ASSEMBLY
| (a) Remove the 3 screws and electric parking brake switch assembly. |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL ELECTRIC PARKING BRAKE SWITCH ASSEMBLY
(a) Install the electric parking brake switch assembly with the 3 screws.
2. INSTALL CONSOLE PANEL SUB-ASSEMBLY
Click here
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Lighting System (w/o Automatic Headlight Beam Level Control System): Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected. System Name See Procedure Lane Control System Pre-collision Sys ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Blind Spot Monitor System: Short to GND in Outer Mirror Indicator(Slave) (C1AB3)
DESCRIPTION This DTC is stored when the blind spot monitor sensor RH detects a short to ground in the outer rear view mirror indicator RH. DTC No. Detection Item DTC Detection Condition Trouble Area C1AB3 Short to GND in Outer Mirror Indicator(Slave) Both of the following condition ...