DESCRIPTION
DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | Note |
---|---|---|---|---|---|
C060B12 | Left Electric Parking Brake Actuator Control Circuit Short to Battery |
|
| DTC stored | An electric parking brake system malfunction is displayed on the multi-information display. |
WIRING DIAGRAM
Click here
CAUTION / NOTICE / HINT
NOTICE:
Click here
PROCEDURE
1. | CHECK FOR SHORT TO +B |
(a) Turn the engine switch off.
(b) Make sure the No. 2 parking brake wire assembly is securely installed.
(c) Disconnect the o2 parking brake actuator assembly LH connector.
(d) Measure the voltage according to the value(s) in the table below. Standard Voltage:
|
|
OK | ![]() | REPLACE PARKING BRAKE ACTUATOR ASSEMBLY LH |
|
2. | CHECK FOR SHORT TO +B |
(a) Disconnect the oS1 No. 2 parking brake wire assembly connector.
(b) Measure the voltage according to the value(s) in the table below. Standard Voltage:
|
|
OK | ![]() | REPLACE NO. 2 PARKING BRAKE WIRE ASSEMBLY |
|
3. | CHECK FOR SHORT TO +B |
(a) Disconnect the oS1 No. 2 parking brake wire assembly connector.
(b) Disconnect the A41 skid control ECU (brake actuator assembly) connector.
(c) Measure the voltage according to the value(s) in the table below.
*a | Front view of wire harness connector | *b | (to Skid Control ECU (Brake Actuator Assembly)) |
*c | (to No. 2 Parking Brake Wire Assembly) | - | - |
Standard Voltage:
Tester Connection | Condition | Specified Condition |
---|---|---|
oS1-1 or A41-3 (MRL+) - Body ground | Always | Below 1 V |
oS1-2 or A41-2 (MRL-) - Body ground | Always | Below 1 V |
OK | ![]() | REPLACE SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY) |
NG | ![]() | REPAIR OR REPLACE HARNESS OR CONNECTOR |
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Hood Support: Components
COMPONENTS ILLUSTRATION *1 OUTER COWL TOP PANEL SUB-ASSEMBLY - - N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *1 HOOD STAY BRACKET *2 HOOD SUPPORT ASSEMBLY *3 HOOD SUPPORT BRACKET - - N*m (kgf*cm, ft.*lbf): Specified torque - - ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Smart Access System With Push-button Start (for Entry Function): Open in Rear Door Electrical Antenna Circuit, Drivers Side (B27A3)
DESCRIPTION The certification ECU (smart key ECU assembly) generates a request signal and transmits the signal to the rear door outside handle assembly (for driver side) (electrical key antenna) at intervals of 0.25 seconds. For the rear door outside handle assembly (for driver side) (electrical key ...