CALIBRATION
DESCRIPTION
(a) When the 4WD ECU assembly is replaced with a known good one from another vehicle or the acceleration sensor (airbag ECU assembly*1 or yaw rate sensor assembly*2) is replaced, perform calibration.
(b) Follow the chart to perform calibration.
| Part Replaced | Necessary Operation |
|---|---|
| 4WD ECU assembly (When replaced with a known good one from another vehicle) | Clear zero point calibration data |
| Acceleration sensor (airbag sensor assembly)*1 Acceleration sensor (yaw rate sensor assembly)*2 |
|
HINT:
PERFORM CALIBRATION
(a) Clear the zero point calibration data.
(1) Turn the engine switch off.
(2) Connect the Techstream to the DLC3.
(3) Turn the engine switch on (IG).
(4) Turn the Techstream on.
(5) Enter the following menus: Chassis / Four Wheel Drive / Utility / Reset Memory.
Chassis > Four Wheel Drive > Utility| Tester Display |
|---|
| Reset Memory |
(6) Operate the Techstream to clear the data.
System Diagram
How To Proceed With TroubleshootingLexus RX (RX 350L, RX450h) 2016-2026 Owners Manual > Do-it-yourself
maintenance: Windshield wiper inserts
Replacing a windshield wiper insert
1. Change the rest position of the windshield wipers to the service position
using
the wiper lever and then lift a windshield wiper.
2. While pressing and holding the
wiper blade lock release button,
remove the wiper blade.
When performing this operation ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Airbag System: Lost Communication with Restraints Occupant Classification System Module (U0154)
DESCRIPTION The airbag sensor assembly sends/receives signals to/from each ECU via CAN communication. DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Test Mode / Check Mode U0154 Lost Communication with Restraints Occupant Classification System Module ...