MANUAL SHIFTING TEST
MANUAL SHIFTING TEST
HINT:
(a) Disconnect the transmission wire connector.
HINT:
It is possible to deactivate the electrical shift control by disconnecting the transmission wire. The gears can then be changed mechanically with the shift lever.
(b) Drive the vehicle with the transmission wire connector disconnected. Move the shift lever to each position to check whether the gear changes as shown in the table below.
| Shift Lever Position | Gear |
|---|---|
| P | P |
| R | R |
| D | 3rd No Shift (Gears will not change) |
(c) Connect the transmission wire connector.
(d) Clear the DTCs.
Click here
Hydraulic Test
RegistrationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Safety Connect System: Emergency Call Switch Circuit Short to Ground (B15C511,B15C513)
DESCRIPTION If the DCM (telematics transceiver) detects an error in the communication between the DCM (telematics transceiver) and the map light assembly (manual (SOS) switch) as a result of the DCM (telematics transceiver) self check, this DTC will be stored. DTC No. Detection Item DTC Detec ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sfi System: Diagnosis System
DIAGNOSIS SYSTEM DESCRIPTION When troubleshooting OBD II (On-Board Diagnostics) vehicles, the Techstream (complying with SAE J1978) must be connected to the DLC3 (Data Link Connector 3) of the vehicle. Various data in the vehicle's ECM (Engine Control Module) can be then read. OBD II regulations re ...