INSTALLATION
PROCEDURE
1. INSTALL COMBINATION SWITCH ASSEMBLY
(a) Install the combination switch assembly to the console box ornament with the 3 screws.
2. INSTALL CONSOLE BOX ORNAMENT
(a) Install the console box ornament to the shifting hole frame sub-assembly with the 4 screws.
(b) Install the console box bracket with the 2 screws.
3. INSTALL CONSOLE PANEL SUB-ASSEMBLY
Click here
4. INSTALL INSTRUMENT CLUSTER FINISH PANEL ORNAMENT
Click here
5. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
Click here
6. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
Click here
7. INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
Click here
8. INSTALL REAR CONSOLE UPPER PANEL
Click here
ComponentsLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Speed Sensor (for 2wd): Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor is malfunctioning, replace the rear axle hub and ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Immobiliser System: Dtc Check / Clear
DTC CHECK / CLEAR NOTICE: When using the Techstream with the engine switch off, connect the Techstream to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select the vehicle type under man ...