INSPECTION
PROCEDURE
1. INSPECT COMBINATION SWITCH ASSEMBLY
(a) Inspect the NORMAL or NORMAL CUSTOMIZE mode switch:
| (1) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the combination switch assembly. |
|
(b) Inspect the SPORT or SPORT S/S+ mode switch:
| (1) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the combination switch assembly. |
|
(c) Inspect the illumination:
| (1) Apply battery voltage to the combination switch assembly and check that the combination switch assembly illuminates. Standard:
If the result is not as specified, replace the combination switch assembly. |
|
Components
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Can Communication System: Open in Bus 1 Main Bus Line
DESCRIPTION There may be an open circuit in one of the bus 1 main lines when the resistance between terminals 23 (CA1H) and 8 (CA1L) of the network gateway ECU is 70 Ω or higher. Symptom Trouble Area Resistance between terminals 23 (CA1H) and 8 (CA1L) of network gateway ECU is 70 Ω or hig ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Curtain Shield Airbag Assembly (w/ Rear No. 2 Seat): Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY NOTICE: When installing a curtain shield airbag assembly, have assistants hold it to prevent it from ...