DISASSEMBLY
PROCEDURE
1. REMOVE DIFFERENTIAL CASE TAPERED ROLLER BEARING (FRONT SIDE)
| (a) Using SST, remove the differential case tapered roller bearing (front side inner race) from the differential case assembly. SST: 09950-00020 SST: 09950-00030 SST: 09950-40011 09957-04010 SST: 09950-60010 09951-00480 |
|
| (b) Using SST, remove the differential case tapered roller bearing (front side outer race) from the transaxle housing. SST: 09308-00010 |
|
2. REMOVE DIFFERENTIAL CASE TAPERED ROLLER BEARING (REAR SIDE)
| (a) Using SST, remove the differential case tapered roller bearing (rear side inner race) from the differential case assembly. SST: 09950-00020 SST: 09950-00030 SST: 09950-40011 09957-04010 SST: 09950-60010 09951-00350 09951-00540 09952-06010 NOTICE: The differential case tapered roller bearing (rear side inner race) cannot be removed as is. Break the bearing cage and remove the bearing cage and rollers first, and then remove the differential case tapered roller bearing (rear side inner race). |
|
| (b) Using SST, remove the differential case tapered roller bearing (rear side outer race) and shim from the automatic transaxle case sub-assembly. SST: 09308-00010 |
|
3. REMOVE FRONT DRIVE SHAFT OIL SEAL RH
| (a) Using SST and a hammer, remove the front drive shaft oil seal RH from the transaxle housing. SST: 09950-60010 09951-00550 SST: 09950-70010 09951-07200 |
|
4. REMOVE FRONT DRIVE SHAFT OIL SEAL LH
| (a) Using SST and a hammer, remove the front drive shaft oil seal LH from the automatic transaxle case sub-assembly. SST: 09950-60010 09951-00650 SST: 09950-70010 09951-07200 |
|
Components
InspectionLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Valve Body Assembly: Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE MANUAL VALVE (a) Remove the manual valve from the transmission valve body assembly. (b) Remove the E-ring and separate the manual valve connecting rod from the manual valve. *1 Manual Valve Connecting Rod *2 Manual Valve *3 ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Brake Control / Dynamic Control Systems: Brake Pedal Load Sensing Switch
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT BRAKE PEDAL SUPPORT ASSEMBLY (a) Make sure that there is no looseness in the locking part and the connecting part of the connector. *a Component without harness connected (Brake Pedal Load Sensing Switch (Brake Pedal S ...