ADJUSTMENT
CAUTION / NOTICE / HINT
NOTICE:
Before installing the transmission control cable assembly, check that the park/neutral position switch assembly and the shift lever are in neutral.
PROCEDURE
1. SECURE VEHICLE
(a) Fully apply the parking brake and chock a wheel.
CAUTION:
2. REMOVE CONSOLE BOX ASSEMBLY
Click here
3. REMOVE FRONT NO. 1 CONSOLE BOX INSERT
Click here
4. ADJUST SHIFT LEVER POSITION
(a) Move the shift lever to N.
| (b) Disconnect the transmission control cable assembly from the transmission floor shift assembly. |
|
| (c) Disengage the 2 claws and disconnect the transmission control cable assembly from the transmission floor shift assembly. |
|
| (d) Slide the cover of the transmission control cable assembly and pull the lock piece outward as shown in the illustration. |
|
| (e) Engage the 2 claws to connect the transmission control cable assembly to the transmission floor shift assembly. NOTICE: Make sure that the transmission control cable assembly is securely connected. |
|
| (f) Connect the transmission control cable assembly to the transmission floor shift assembly. NOTICE:
|
|
(g) Using your fingers, gently pull the cable rod towards the rear of the vehicle to remove backlash.
| (h) Push the lock piece into the adjuster case. NOTICE: Make sure that the park/neutral position switch assembly and the shift lever are in neutral. |
|
| (i) Slide the cover of the transmission control cable assembly as shown in the illustration. NOTICE:
|
|
(j) After adjusting the shift lever position, check the position and operation of the shift lever. If there is a problem, adjust the shift lever position again.
5. INSTALL FRONT NO. 1 CONSOLE BOX INSERT
Click here
6. INSTALL CONSOLE BOX ASSEMBLY
Click here
Components
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Windshield Deicer System: Terminals Of Ecu
TERMINALS OF ECU CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY *A w/o Seat Heater System *B w/ Seat Heater System (a) Disconnect the J43 air conditioning amplifier assembly connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the valu ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Center Seat Outer Belt Assembly(w/ Rear No. 2 Seat): Inspection
INSPECTION PROCEDURE 1. INSPECT REAR CENTER SEAT OUTER BELT ASSEMBLY (a) After installing the rear center seat outer belt assembly, check the ELR function. NOTICE: Do not disassemble the retractor. (1) Move the seatback of the rear No. 1 seat assembly RH to the upright position. Check that the se ...