DISASSEMBLY
PROCEDURE
1. INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY
Click here
2. REMOVE CLUTCH DRUM OIL SEAL RING
| (a) Remove the 4 clutch drum oil seal rings from the stator shaft assembly. |
|
3. REMOVE VALVE BODY OIL STRAINER ASSEMBLY
| (a) Using a T30 "TORX" socket wrench, remove the 2 bolts and valve body oil strainer assembly from the stator shaft assembly. |
|
4. REMOVE STATOR SHAFT ASSEMBLY
| (a) Using a T30 "TORX" socket wrench, remove the 10 bolts and stator shaft assembly from the front oil pump body and gear sub-assembly. NOTICE: Keep the gears in the order they were removed. |
|
5. INSPECT CLEARANCE OF FRONT OIL PUMP BODY AND GEAR SUB-ASSEMBLY
Click here
6. REMOVE FRONT OIL PUMP DRIVE GEAR
| (a) Remove the front oil pump drive gear from the front oil pump body sub-assembly. |
|
7. REMOVE FRONT OIL PUMP DRIVEN GEAR
| (a) Remove the front oil pump driven gear from the front oil pump body sub-assembly. |
|
8. REMOVE FRONT OIL PUMP BODY O-RING
| (a) Remove the front oil pump body O-ring from the front oil pump body sub-assembly. |
|
9. REMOVE FRONT OIL PUMP OIL SEAL
| (a) Secure the front oil pump body sub-assembly in a soft jaw vise. |
|
(b) Using SST, remove the front oil pump oil seal from the front oil pump body sub-assembly.
SST: 09308-00010
Components
ReassemblyLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Front Door Belt Moulding: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front door belt moulding removal/installation are shown below. Necessary Procedures After Parts Removed/ ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Headup Display System: Lost Communication with EMV (B1321)
DESCRIPTION After the headup display (meter mirror sub-assembly) has started, the headup display (meter mirror sub-assembly) attempts to detect the radio receiver assembly by performing communication via local bus. This DTC is stored when the radio receiver assembly has been detected but communicati ...