REASSEMBLY
PROCEDURE
1. INSTALL FRONT OIL PUMP OIL SEAL
| (a) Using SST and a hammer, install a new front oil pump oil seal to the front oil pump body sub-assembly. SST: 09350-32014 09351-32140 Standard Depth: -0.2 to 0.2 mm (-0.00787 to 0.00787 in.) |
|
(b) Coat the lip of the front oil pump oil seal with MP grease.
2. INSTALL FRONT OIL PUMP BODY O-RING
| (a) Coat a new front oil pump body O-ring with ATF and install it to the front oil pump body sub-assembly. NOTICE: Ensure that the front oil pump body O-ring is not twisted. |
|
3. INSTALL FRONT OIL PUMP DRIVEN GEAR
| (a) Coat the front oil pump driven gear with ATF and install it to the front oil pump body sub-assembly with the marked side facing upward. |
|
4. INSTALL FRONT OIL PUMP DRIVE GEAR
| (a) Coat the front oil pump drive gear with ATF and install it to the front oil pump body sub-assembly with the marked side facing upward. |
|
5. INSTALL STATOR SHAFT ASSEMBLY
| (a) Using a T30 "TORX" socket wrench, install the stator shaft assembly to the front oil pump body and gear sub-assembly with the 10 bolts. Torque: 9.8 N·m {100 kgf·cm, 87 in·lbf} |
|
6. INSTALL VALVE BODY OIL STRAINER ASSEMBLY
| (a) Using a T30 "TORX" socket wrench, install a new valve body oil strainer assembly to the stator shaft assembly with the 2 bolts. Torque: 5.4 N·m {55 kgf·cm, 48 in·lbf} |
|
7. INSTALL CLUTCH DRUM OIL SEAL RING
| (a) Coat 4 new clutch drum oil seal rings with ATF and install them to the stator shaft assembly. |
|
8. INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY
Click here
DisassemblyLexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Seat Heater System: Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Air Conditioner / Trouble Codes. Body Electrical > Air Conditioner > Trouble Codes (e) Check for DTCs. CLEAR DTC ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Steering Gear: Components
COMPONENTS ILLUSTRATION *A for TMC Made *B for TMMC Made *1 NO. 2 ENGINE UNDER COVER *2 STEERING INTERMEDIATE SHAFT ASSEMBLY *3 TIE ROD ASSEMBLY LH *4 COTTER PIN Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stoppin ...