INSTALLATION
PROCEDURE
1. INSTALL NO. 1 SWITCH WIRE
HINT:
Perform this procedure only when replacement of the No. 1 switch wire is necessary.
(a) Engage the 6 clamps to install the No. 1 switch wire to the steering wheel assembly.
(b) Engage the 2 guides.
(c) Connect the steering vibration and heater ECU connector.
2. INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)
(a) Connect the 2 shift paddle switch (transmission shift switch assembly) connectors.
(b) Engage the 2 claws to install the 2 shift paddle switches (transmission shift switch assemblies) to the steering wheel assembly.
(c) Install 4 new screws.
Torque:
1.7 N·m {17 kgf·cm, 15 in·lbf}
3. INSTALL STEERING PAD SWITCH ASSEMBLY
Click here
4. INSTALL CRUISE CONTROL MAIN SWITCH
Click here
5. INSTALL STEERING WHEEL ASSEMBLY
Click here
Inspection
Speed SensorLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Back Door System (w/ Outside Door Control Switch): Initialization
INITIALIZATION INITIALIZE MULTIPLEX NETWORK DOOR ECU NOTICE: Initialization of the multiplex network door ECU (back door initial position learning) is necessary if any of the following have been performed with the back door open.
The cable is disconnected from the negative (-) battery terminal.
...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Air Fuel Ratio Sensor: Components
COMPONENTS ILLUSTRATION *A for TMC Made *B for TMMC Made *1 AIR FUEL RATIO SENSOR (for Bank 1) *2 AIR FUEL RATIO SENSOR (for Bank 2) *3 NO. 2 ENGINE UNDER COVER *4 NO. 2 EXHAUST MANIFOLD HEAT INSULATOR *5 V-BANK COVER SUB-ASSEMBLY - - N*m (kgf*cm, ft.*l ...