REMOVAL
PROCEDURE
1. REMOVE FRONT DOOR SCUFF PLATE LH
Click here
2. REMOVE COWL SIDE TRIM BOARD
Click here
3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
4. REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY
NOTICE:
| (a) Disconnect the accelerator pedal sensor assembly connector. |
|
(b) Remove the 2 nuts and accelerator pedal sensor assembly.
NOTICE:
If the accelerator pedal sensor assembly has been struck or dropped, replace it.
(c) Separate the rod of the accelerator pedal sensor assembly from the accelerator pedal assembly to remove the accelerator pedal sensor assembly.
5. REMOVE ACCELERATOR PEDAL PAD
| (a) Disengage the 2 claws and remove the accelerator pedal pad. |
|
6. REMOVE ACCELERATOR PEDAL
| (a) Remove the 2 bolts and accelerator pedal. |
|
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Wiper And Washer System: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Lighting System (w/o Automatic Headlight Beam Level Control System): Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected. System Name See Procedure Lane Control System Pre-collision Sys ...