INSTALLATION
PROCEDURE
1. INSTALL ACCELERATOR PEDAL
(a) Install the accelerator pedal with the 2 bolts.
Torque:
5.4 N·m {55 kgf·cm, 48 in·lbf}
2. INSTALL ACCELERATOR PEDAL PAD
(a) Engage the 2 claws to install the accelerator pedal pad.
3. INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY
NOTICE:
(a) Install the rod of the accelerator pedal sensor assembly to the accelerator pedal assembly.
(b) Install the accelerator pedal sensor assembly with the 2 nuts.
Torque:
5.4 N·m {55 kgf·cm, 48 in·lbf}
(c) Connect the accelerator pedal sensor assembly connector.
4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
5. INSTALL COWL SIDE TRIM BOARD
Click here
6. INSTALL FRONT DOOR SCUFF PLATE LH
Click here
On-vehicle Inspection
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Horn: Relay
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT HORN RELAY ASSEMBLY (a) Remove the HORN relay. *a Component without harness connected (HORN Relay) (b) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Conne ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sliding Roof System: Remote Control System does not Operate
DESCRIPTION The main body ECU (multiplex network body ECU) receives remote control signals from the driver door key cylinder or electrical key transmitter sub-assembly. Then, the main body ECU (multiplex network body ECU) activates the power window motor and sends the remote control signals to the s ...