ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Powertrain / Engine / Data List / Accelerator Position Sensor No. 1 Voltage and Accelerator Position Sensor No. 2 Voltage.
Powertrain > Engine > Data List| Tester Display |
|---|
| Accelerator Position Sensor No.1 Voltage |
| Accelerator Position Sensor No.2 Voltage |
(e) Read the values displayed on the Techstream.
Standard Voltage:
| Techstream Display | Condition | Specified Condition |
|---|---|---|
| Accelerator Position Sensor No. 1 Voltage | Accelerator pedal fully released | 0.5 to 1.1 V |
| Accelerator pedal fully depressed | 2.6 to 4.5 V | |
| Accelerator Position Sensor No. 2 Voltage | Accelerator pedal fully released | 1.2 to 2.0 V |
| Accelerator pedal fully depressed | 3.4 to 4.75 V |
If the result is not as specified, check the accelerator pedal sensor assembly, wire harness and ECM.
Components
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Automatic Transaxle System: Intermediate Shaft Speed Sensor "A" Circuit Short to Battery (P079112,P079114,P079131)
DESCRIPTION The transmission revolution sensor (NC) detects the rotation speed of the counter gear which shows the output shaft speed of automatic transaxle assembly. Based on the transmission revolution sensor (NC) signal and the transmission revolution sensor (NT and NC3) signals, the ECM controls ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Evaporator Temperature Sensor: Removal
REMOVAL PROCEDURE 1. REMOVE REAR COOLING UNIT ASSEMBLY Click here 2. REMOVE REAR NO. 2 COOLING UNIT DAMPER SERVO SUB-ASSEMBLY Click here 3. REMOVE REAR NO. 1 COOLING UNIT DAMPER SERVO SUB-ASSEMBLY Click here 4. REMOVE NO. 1 COOLING UNIT BRACKET Click here 5. REMOVE NO. 2 COOLING UNIT BRAC ...