Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT AIR FUEL RATIO SENSOR

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 (HA1A) - 2 (+B)

1 (HA2A) - 2 (+B)

20°C (68°F)

1.6 to 3.2 Ω

1 (HA1A) - 4 (A1A-)

1 (HA2A) - 4 (A2A-)

Always

10 kΩ or higher

If the result is not as specified, replace the air fuel ratio sensor.

*A

for Bank 1

*B

for Bank 2

*a

Component without harness connected

(Air Fuel Ratio Sensor)

    Components
    COMPONENTS ILLUSTRATION *A for TMC Made *B for TMMC Made *1 AIR FUEL RATIO SENSOR (for Bank 1) *2 AIR FUEL RATIO SENSOR (for Bank 2) *3 NO. 2 ENGINE UNDER COVER *4 NO. 2 ...

    Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during air ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Blower Motor: Installation
    INSTALLATION PROCEDURE 1. INSTALL REAR BLOWER MOTOR WITH FAN SUB-ASSEMBLY (a) Install the rear blower motor with fan sub-assembly with the 3 screws. NOTICE: Replace the rear blower motor with fan sub-assembly if it has been dropped or subjected to a severe impact. (b) Connect each connector. 2. INST ...

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Dynamic Torque Control Awd System: Precaution
    PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected: System See Procedure Lane Control System Pre-collision System ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2026 Copyright www.lexusrx.net
    0.0107