ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY
(a) Connect the Techstream to the DLC3.
(b) Start the engine.
(c) Turn the Techstream on.
(d) Inspect the camshaft timing oil control solenoid assembly (for intake side).
(1) Enter the following menus: Powertrain / Engine / Active Test / Control the Intake VVT OCV Duty Ratio Bank 1 / Data List / Intake VVT Change Angle Bank 1.
Powertrain > Engine > Active Test Active Test Display |
---|
Control the Intake VVT OCV Duty Ratio Bank 1 |
Data List Display |
---|
Intake VVT Change Angle Bank 1 |
(2) Read the Data List while performing the Active Test with the engine idling.
OK:
Techstream Operation | Data List(Intake VVT Change Angle Bank 1) |
---|---|
-100% to 100% | Varies by 70 DegFR or more |
If the result is not as specified, check the camshaft timing oil control solenoid assembly, wire harness and ECM.
(e) Inspect the camshaft timing oil control solenoid assembly (for exhaust side).
(1) Enter the following menus: Powertrain / Engine / Active Test / Control the Exhaust VVT OCV Duty Ratio Bank 1 / Data List / Exhaust VVT Change Angle Bank 1.
Powertrain > Engine > Active Test Active Test Display |
---|
Control the Exhaust VVT OCV Duty Ratio Bank 1 |
Data List Display |
---|
Exhaust VVT Change Angle Bank 1 |
(2) Read the Data List while performing the Active Test with the engine idling.
OK:
Techstream Operation | Data List (Exhaust VVT Change Angle Bank 1) |
---|---|
-100% to 100% | Varies by 70 DegFR or more |
If the result is not as specified, check the camshaft timing oil control solenoid assembly, wire harness and ECM.
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Roof Antenna: Installation
INSTALLATION PROCEDURE 1. INSTALL TELEPHONE ANTENNA ASSEMBLY (a) When reusing the telephone antenna assembly: (1) Install a new seal. (b) Push the telephone antenna assembly in the direction indicated by the arrow (1) shown in the illustration to engage the guide. Install in this Direction (1 ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Steering Heater Switch: Installation
INSTALLATION PROCEDURE 1. INSTALL STEERING HEATER SWITCH (INTEGRATION CONTROL AND PANEL ASSEMBLY) (a) Engage the 4 claws to install the steering heater switch (integration control and panel assembly). 2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Click here 3. CONNECT HOOD LOCK CONT ...