INSPECTION
PROCEDURE
1. INSPECT CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY
HINT:
Use the same procedure for the intake side and exhaust side.
(a) Check the resistance.
| (1) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the camshaft timing oil control solenoid assembly. |
|
(b) Stroke Amount Inspection
(1) Using vernier calipers, measure length (A) and (B) with the shaft of the camshaft timing oil control solenoid assembly set in the respective positions shown in the illustration.
| *A | Type A | *B | Type B |
| *a | Shaft Side Facing Down | *b | Shaft Side Facing Up |
| *c | Shaft | - | - |
NOTICE:
Do not apply battery voltage to the terminals of the camshaft timing oil control solenoid assembly.
HINT:
If the shaft does not extend under its own weight, extend the shaft with your fingers.
(2) Calculate the stroke amount based on the difference of length (A) and (B).
Standard:
6.5 mm (0.256 in.) or more
HINT:
Stroke amount = length (A) - length (B)
If the value is not as specified, replace the camshaft timing oil control solenoid assembly.
Removal
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Combination Meter: Reassembly
REASSEMBLY PROCEDURE 1. INSTALL COMBINATION METER GLASS (for Optitron Meter Type) (a) Engage the 8 claws to install the combination meter glass. 2. INSTALL COMBINATION METER GLASS (for TFT Meter Type) (a) Engage the 9 claws to install the combination meter glass. ...
Lexus RX (RX 350L, RX450h) 2016-2026 Owners Manual > Specifications: Fuel information
You must only use unleaded gasoline.
Select premium unleaded gasoline with an octane rating of 91 (Research
Octane Number 96) or higher required for optimum engine performance
and fuel economy.
If the octane rating is less than 91, damage to the engine may occur and may
void the vehicle war ...