ON-VEHICLE INSPECTION
PROCEDURE
1. REMOVE CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY
Click here
2. INSPECT CAMSHAFT TIMING GEAR BOLT
(a) for intake side:
| (1) Check the stroke of the plunger in the center of the camshaft timing gear bolt. Standard Stroke: 4.5 mm (0.177 in.) or more HINT: When pressing the plunger, there may be a stepped feeling. This is not a malfunction. If the result is not as specified, replace the camshaft timing gear bolt. |
|
(b) for exhaust side:
| (1) Check the stroke of the plunger in the center of the camshaft timing gear bolt. Standard Stroke: 2.2 mm (0.0866 in.) or more HINT: When pressing the plunger, there may be a stepped feeling. This is not a malfunction. If the result is not as specified, replace the camshaft timing gear bolt. |
|
3. INSTALL CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY
Click here
Components
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Valve Body Assembly: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission valve body assembly removal/installation are shown below. Necessary Procedures After Parts ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear No. 1 Seat Inner Belt Assembly(for 60/40 Split Seat Type Rh Side): Inspection
INSPECTION PROCEDURE 1. INSPECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY RH (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 1 - 2 Rear No. 1 RH seat belt unfastened Below 1 Ω Rear No. 1 ...