INSTALLATION
PROCEDURE
1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR
HINT:
Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.
Click here
(a) Apply a light coat of engine coolant to the O-ring of the engine coolant temperature sensor.
NOTICE:
If reusing the engine coolant temperature sensor, be sure to inspect the O-ring.
(b) Install the engine coolant temperature sensor to the water outlet with the clip.
NOTICE:
(c) Connect the engine coolant temperature sensor connector.
2. ADD ENGINE COOLANT
Click here
3. INSPECT FOR COOLANT LEAK
Click here
4. INSTALL V-BANK COVER SUB-ASSEMBLY
Click here
5. PERFORM INITIALIZATION
(a) Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.
Click here
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Main Body Ecu: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during main body ECU removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/R ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Seat Assembly (for 60/40 Split Seat Type Rh Side): Inspection
INSPECTION PROCEDURE 1. PRECAUTION NOTICE: After performing the following check, initialize the fold seat control ECU (initial position reset and initial position memorization). Click here 2. INSPECT REAR SEATBACK FRAME SUB-ASSEMBLY RH (a) Check the operation of the reclining motor. (1) Apply batt ...