Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: Removal

REMOVAL

CAUTION / NOTICE / HINT

NOTICE:

If both left and right front flexible hoses are disconnected at the same time, be sure to place an identification mark on each hose to indicate its installation position.

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. REMOVE FRONT WHEEL

Click here

2. DRAIN BRAKE FLUID

NOTICE:

If brake fluid leaks onto any painted surface, immediately wash it off.

3. REMOVE FRONT FLEXIBLE HOSE

(a) Remove the union bolt and gasket, and disconnect the front flexible hose from the front disc brake cylinder assembly.

(b) Using a union nut wrench, disconnect the brake line while holding the front flexible hose with a wrench.

NOTICE:

  • Do not kink or damage the brake line.
  • Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting parts.

(c) Remove the clip and disconnect the front flexible hose from the vehicle.

(d) Remove the bolt and front flexible hose, and separate the front speed sensor from the shock absorber assembly.

    Components
    COMPONENTS ILLUSTRATION *1 FRONT FLEXIBLE HOSE *2 UNION BOLT *3 GASKET *4 BRAKE LINE *5 FRONT SPEED SENSOR - - Tightening torque for "Major areas involving basic v ...

    Installation
    INSTALLATION CAUTION / NOTICE / HINT NOTICE: Because the left and right front flexible hoses are not interchangeable, verify the part number when installing the front flexible hoses. When reusing ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Axle Carrier (for 2wd): Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear axle carrier sub-assembly removal/installation are shown below. Necessary Procedures After Parts R ...

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Camshaft Oil Control Valve (for Bank 1): On-vehicle Inspection
    ON-VEHICLE INSPECTION PROCEDURE 1. REMOVE CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY Click here 2. INSPECT CAMSHAFT TIMING GEAR BOLT (a) for intake side: (1) Check the stroke of the plunger in the center of the camshaft timing gear bolt. Standard Stroke: 4.5 mm (0.177 in.) or more HINT: W ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2026 Copyright www.lexusrx.net
    0.1271