REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during heated oxygen sensor removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Inspection After Repair |
| |
PROCEDURE
1. REMOVE FRONT FLOOR COVER LH
Click here
2. REMOVE FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY
Click here
3. REMOVE HEATED OXYGEN SENSOR (for Bank 1)
| (a) Remove the wire harness clamp bracket from the heated oxygen sensor. |
|
| (b) Using SST, remove the heated oxygen sensor from the front No. 3 exhaust pipe sub-assembly. SST: 09224-00011 NOTICE: If the heated oxygen sensor has been struck or dropped, replace it. |
|
4. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET (for Lower Side)
Click here
5. REMOVE FRONT EXHAUST PIPE ASSEMBLY
Click here
6. REMOVE HEATED OXYGEN SENSOR (for Bank 2)
| (a) Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly. SST: 09224-00011 |
|
Components
InspectionLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Millimeter Wave Radar Sensor: Adjustment
ADJUSTMENT CAUTION / NOTICE / HINT CAUTION: Radiofrequency radiation exposure information:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be kept with minimum distance of 20 cm (7.87 in.) between the radiator (antenna) ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Tilt And Power Telescopic Steering Column System: Terminals Of Ecu
TERMINALS OF ECU MULTIPLEX TILT AND TELESCOPIC ECU *a Component without harness connected (Multiplex Tilt and Telescopic ECU) - - (a) Measure the voltage and resistance according to the value(s) in the table below. Terminal No. (Symbol) Wiring Color Terminal Description Conditi ...