Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: Inspection

Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual / Engine & Hybrid System / 2gr-fks (engine Control) / Heated Oxygen Sensor / Inspection

INSPECTION

PROCEDURE

1. INSPECT HEATED OXYGEN SENSOR

(a) for Bank 1:

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

2 (HT1B) - 1 (+B)

20°C (68°F)

5 to 10 Ω

2 (HT1B) - 3 (E2)

Always

10 kΩ or higher

If the result is not as specified, replace the heated oxygen sensor.

*a

Component without harness connected

(Heated Oxygen Sensor)

(b) for Bank 2:

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 (HT2B) - 2 (+B)

20°C (68°F)

5 to 10 Ω

1 (HT2B) - 4 (E2)

Always

10 kΩ or higher

If the result is not as specified, replace the heated oxygen sensor.

*a

Component without harness connected

(Heated Oxygen Sensor)
    Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during heat ...

    Installation
    INSTALLATION PROCEDURE 1. INSTALL HEATED OXYGEN SENSOR (for Bank 2) HINT: Perform "Inspection After Repairs" after replacing the heated oxygen sensor. Click here (a) Using SST, install the heate ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Navigation System: NTSC Disconnected (from Park Assist/Monitoring ECU) (B1535,C1622)
    DESCRIPTION These DTCs are stored if the radio receiver assembly judges that the signals or signal lines between the rear television camera assembly and the multi-display assembly are not normal as a result of its self check. DTC No. Detection Item DTC Detection Condition Trouble Area B ...

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Seat Switch (for Rear No. 2 Seat): Installation
    INSTALLATION PROCEDURE 1. INSTALL NO. 1 FOLD SEAT SWITCH ASSEMBLY (for Rear Side) (a) Engage the 2 guides and 4 claws to install the No. 1 fold seat switch assembly as shown in the illustration. Install in this Direction 2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (for Rear Side) Click her ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2026 Copyright www.lexusrx.net
    0.0102