COMPONENTS
ILLUSTRATION
| *1 | FUEL DELIVERY PIPE RH | *2 | FUEL DELIVERY PIPE WITH SENSOR ASSEMBLY LH |
| *3 | FUEL INJECTOR ASSEMBLY | *4 | FUEL INJECTOR SEAL |
| *5 | NO. 2 FUEL PIPE SUB-ASSEMBLY | *6 | WIRE HARNESS CLAMP BRACKET |
| *7 | NO. 3 FUEL INJECTOR BACK-UP RING | *8 | O-RING |
| *9 | NO. 1 FUEL INJECTOR BACK-UP RING | *10 | NOZZLE HOLDER CLAMP |
| *11 | INJECTOR VIBRATION INSULATOR | *12 | C-RING |
| *13 | NO. 6 ENGINE WIRE | *14 | NO. 7 ENGINE WIRE |
| Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | | N*m (kgf*cm, ft.*lbf): Specified torque |
| * | For use with a union nut wrench | ● | Non-reusable part |
InspectionLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Wiper Motor: On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT REAR WIPER MOTOR AND BRACKET ASSEMBLY *A w/o Rear No. 2 Seat *B w/ Rear No. 2 Seat *a Alignment Mark - - (a) Operate the rear wiper motor and bracket assembly. (b) Stop the rear wiper motor and bracket assembly operation. (c) Check th ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Blower Motor: Removal
REMOVAL PROCEDURE 1. REMOVE REAR NO. 2 SEAT ASSEMBLY Click here 2. REMOVE REAR FLOOR FINISH PLATE Click here 3. REMOVE REAR DOOR SCUFF PLATE RH HINT: Use the same procedure as for the LH side. Click here 4. REMOVE REAR DOOR INSIDE SCUFF PLATE RH HINT: Use the same procedure as for the LH sid ...