Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: Inspection

Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual / Engine & Hybrid System / 2gr-fks (fuel) / Fuel Pressure Sensor (for High Pressure) / Inspection

INSPECTION

PROCEDURE

1. INSPECT FUEL DELIVERY PIPE WITH SENSOR ASSEMBLY LH (FUEL PRESSURE SENSOR)

NOTICE:

  • Do not remove the fuel pressure sensor from the fuel delivery pipe with sensor assembly LH.
  • If the fuel pressure sensor is removed, replace the fuel delivery pipe with sensor assembly LH (fuel pressure sensor) with a new one.

(a) Check the fuel pressure sensor output voltage.

(1) Apply 5 V between terminals 1 (VC) and 2 (E2).

NOTICE:

  • Be careful when connecting the leads as the fuel pressure sensor may be damaged if the leads are connected to the wrong terminals.
  • Do not apply more than 6 V to terminals 1 (VC) or 2 (E2).

HINT:

If a stable power supply is not available, connect 4 nickel-metal hydride batteries (1.2 V each) or equivalent in series.

*a

Component without harness connected

(Fuel Pressure Sensor)

*b

Voltage Applied between Terminals

(2) Measure the voltage between terminals.

Standard Voltage:

Tester Connection

Condition

Specified Condition

3 (PR) - 2 (E2)

Pressure not applied to fuel pressure sensor

Approximately 0.4 to 0.6 V*

*: The output voltage changes depending on the voltage applied to the terminals.

If the result is not as specified, replace the fuel delivery pipe with sensor assembly LH (fuel pressure sensor).

*a

Component without harness connected

(Fuel Pressure Sensor)
    Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel ...

    Installation
    INSTALLATION PROCEDURE 1. INSTALL FUEL PIPE PLUG SUB-ASSEMBLY (a) Install a new O-ring, new No. 1 fuel injector back-up ring, new No. 2 fuel injector back-up ring and new No. 3 fuel injector back-up r ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Speed Sensor (for 2wd): Installation
    INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor is malfunctioning, replace the rear axle hub and ...

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Seat Heater System: Terminals Of Ecu
    TERMINALS OF ECU CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY (a) Disconnect the J43 air conditioning amplifier assembly connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the connector disconnected. ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2026 Copyright www.lexusrx.net
    0.0098