COMPONENTS
ILLUSTRATION
| *A | for TMC Made | *B | for TMMC Made |
| *1 | CENTER EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst) | *2 | FRONT FLOOR COVER LH |
| *3 | FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY | *4 | HEATED OXYGEN SENSOR (for Bank 1) |
| *5 | NO. 1 EXHAUST PIPE SUPPORT BRACKET (for Lower Side) | *6 | FRONT EXHAUST PIPE ASSEMBLY |
| *7 | HEATED OXYGEN SENSOR (for Bank 2) | *8 | EXHAUST PIPE SUPPORT |
| *9 | EXHAUST PIPE GASKET | *10 | COMPRESSION SPRING |
| N*m (kgf*cm, ft.*lbf): Specified torque | * | For use with SST |
| ● | Non-reusable part | - | - |
ILLUSTRATION
| *A | w/o Rear No. 2 Seat | *B | w/ Rear No. 2 Seat |
| *1 | TAIL EXHAUST PIPE ASSEMBLY | *2 | NO. 2 TAIL EXHAUST PIPE ASSEMBLY |
| *3 | EXHAUST PIPE SUPPORT | *4 | EXHAUST PIPE GASKET |
| N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
Exhaust Pipe
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Smart Access System With Push-button Start (for Start Function): Power Source Mode does not Change to ON (IG and ACC)
DESCRIPTION If any of the following operations are performed, the certification ECU (smart key ECU assembly) receives a signal, and changes the power source mode.
With the electrical key transmitter sub-assembly in the cabin, the engine switch is pressed.
When the transmitter battery of the ele ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Combination Meter: Installation
INSTALLATION PROCEDURE 1. INSTALL COMBINATION METER ASSEMBLY (a) Connect each connector. (b) Engage the clamp. (c) Install the combination meter assembly with the 4 screws. 2. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (a) Connect the connector. (b) Engage the 7 clips as shown in the illus ...