Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual: Definition Of Terms

DEFINITION OF TERMS

Term

Definition

Monitor description

Description of what the ECM monitors and how it detects malfunctions (monitoring purpose and details).

Related DTCs

Group of diagnostic trouble codes that are output by the ECM based on the same malfunction detection logic.

Typical enabling conditions

Preconditions that allow the ECM to detect malfunctions.

With all preconditions satisfied, the ECM stores a DTC when the monitored value(s) exceeds the malfunction threshold(s).

Sequence of operation

The priority order that is applied to monitoring if multiple sensors and components are used to detect the malfunction.

While one sensor is being monitored, the next sensor or component will not be monitored.

Required sensors/Components

The sensors and components that are used by the ECM to detect malfunctions.

Frequency of operation

The number of times that the ECM checks for malfunctions per driving cycle.

"Once per driving cycle" means that the ECM detects a malfunction only once during a single driving cycle.

"Continuous" means that the ECM detects a malfunction every time the enabling conditions are met.

Duration

The minimum time for which the ECM must detect a continuous deviation in the monitored value(s) in order to store a DTC. Timing begins after the "typical enabling conditions" are met.

Typical malfunction thresholds

Value beyond which the ECM will determine that there is a malfunction and stores a DTC.

MIL operation

MIL illumination timing after a malfunction is detected.

"Immediate" means that the ECM illuminates the MIL the instant the ECM determines that there is a malfunction.

"2 driving cycles" means that the ECM illuminates the MIL if the same malfunction is detected again in the next driving cycle.

Component operating range

Normal operation range of sensors and solenoids under normal driving conditions.

Use these ranges as a reference.

The ranges cannot be used to judge if a sensor or solenoid is defective or not.

    Precaution
    PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cab ...

    Parts Location
    PARTS LOCATION ILLUSTRATION *1 MILLIMETER WAVE RADAR SENSOR ASSEMBLY *2 FORWARD RECOGNITION CAMERA *3 SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY) *4 ECM ILLUSTRATION *A for ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Horn: Relay
    On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT HORN RELAY ASSEMBLY (a) Remove the HORN relay. *a Component without harness connected (HORN Relay) (b) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Conne ...

    Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Headlight Cleaner Motor: Inspection
    INSPECTION PROCEDURE 1. INSPECT HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY HINT: This check should be performed with the headlight cleaner motor and pump assembly installed on the washer jar. (a) Fill the washer jar with washer fluid. (b) Connect a battery positive (+) lead to terminal 2 of the he ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2024 Copyright www.lexusrx.net
    0.0192