DESCRIPTION
When the brakes are applied by the dynamic radar cruise control system, the skid control ECU (brake actuator assembly) operates the stop light switch assembly (stop light control relay) to illuminate the stop lights.
If the ECM receives a signal from the skid control ECU (brake actuator assembly) indicating a malfunction of the stop light control relay, DTC P057113 is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | DTC Output from |
|---|---|---|---|---|---|
| P057113 | Brake Switch "A" Circuit Open | When the dynamic radar cruise control system is operating, the ECM detects a signal indicating a stop light control relay malfunction from the skid control ECU (brake actuator assembly) for approximately 1 second or more. | Vehicle stability control system | Does not come on | ECM |
PROCEDURE
| 1. | GO TO VEHICLE STABILITY CONTROL SYSTEM |
HINT:
If DTC P057113 is output by the dynamic radar cruise control system, perform troubleshooting for the vehicle stability control system first.
Click here
| NEXT | | END |
Vehicle Control History
Brake Switch "A" Signal Compare Failure (P057162)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Bumper (w/ Rear No. 2 Seat): Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear bumper assembly removal/installation are shown below. Necessary Procedures After Parts Removed/Ins ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Back Door Drive Unit: Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE BACK WINDOW UPPER PANEL TRIM (w/o Rear No. 2 Seat) Click here 2. REMOVE BACK WINDOW UPPER PANEL TRIM (w/ Rear No. 2 Seat) Click here ...