DTC CHECK / CLEAR
CHECK FOR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Front Radar Sensor / Trouble Codes.
Body Electrical > Front Radar Sensor > Trouble Codes(e) Check for DTCs (Test Failed / Pending / Confirmed).
| Techstream Display | Description |
|---|---|
| Test Failed | Shows the malfunction judgment results during the current trip. |
| Pending | Shows the malfunction judgment results up to now. (Indicates the possibility of a malfunction when no DTC is confirmed.) |
| Confirmed | Shows the DTCs confirmed up to now. (The number of current trips differs for each DTC.) |
HINT:
Freeze frame data is stored respectively for pending DTCs, confirmed DTCs and the latest DTCs.
CLEAR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Front Radar Sensor / Clear DTCs.
Body Electrical > Front Radar Sensor > Clear DTCs(e) Clear the DTCs.
HINT:
Clearing the DTCs will also clear the freeze frame data.
Terminals Of Ecu
Freeze Frame DataLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Yaw Rate And Acceleration Sensor: Installation
INSTALLATION PROCEDURE 1. INSTALL YAW RATE SENSOR ASSEMBLY (a) Install the yaw rate sensor assembly with the 2 bolts. Torque: 14.5 N·m {148 kgf·cm, 11 ft·lbf} NOTICE:
Do not drop the yaw rate sensor assembly.
If the yaw rate sensor assembly is dropped, replace it with a new one.
(b) Conn ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Wiper And Washer System: Headlight Cleaner Motor and Relay Circuit
DESCRIPTION The headlight cleaner motor and pump assembly is controlled by the headlight ECU sub-assembly RH. When the headlight ECU sub-assembly RH receives the washer switch operation signal 5 times with the low beam headlights on, it operates the H-LP CLN relay once. WIRING DIAGRAM CAUTION / NOT ...