DESCRIPTION
The millimeter wave radar sensor assembly performs self-diagnosis to check for misalignment of its beam axis. If misalignment is detected, the millimeter wave radar sensor assembly stores DTC C1A1100.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1A1100 | Front Radar Sensor Optical Axis Misalignment Malfunction | When the engine switch is on (IG), the millimeter wave radar sensor assembly detects beam axis misalignment |
|
CAUTION / NOTICE / HINT
NOTICE:
Click here
PROCEDURE
| 1. | ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY |
(a) Perform millimeter wave radar sensor assembly beam axis adjustment.
Click here
|
| 2. | CHECK FOR DTCs |
(a) Clear the DTCs.
Body Electrical > Front Radar Sensor > Clear DTCs(b) Make sure that the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the system cannot detect the malfunction.
(c) Check for DTCs.
Body Electrical > Front Radar Sensor > Trouble Codes| Result | Proceed to |
|---|---|
| DTC C1A1100 is not output | A |
| DTC C1A1100 is output | B |
| A | | END |
| B | | REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY |
Vehicle Control History
Main Microcomputer in Front Radar Sensor Calibration/Parameter Memory Failure (C1A8C46,C1A8D1C,C1A9000,C1A9100)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Lighting System (w/o Automatic Headlight Beam Level Control System): Automatic High Beam System does not Operate or Operation Indicator does not Illuminate
DESCRIPTION The main body ECU (multiplex network body ECU) controls the automatic high beam system based on signals received from the forward recognition camera. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
Before replacing the main body ECU (multiplex network body ECU), refer to Registration. ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Navigation System: Start Up Signal Circuit between Radio Receiver Assembly and Navigation ECU
DESCRIPTION This circuit includes the navigation ECU and radio receiver assembly. WIRING DIAGRAM PROCEDURE 1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NAVIGATION ECU) (a) Disconnect the J149 radio receiver assembly connector. (b) Disconnect the J153 navigation ECU connector. ...