INSTALLATION
PROCEDURE
1. INSTALL GENERATOR ASSEMBLY
(a) Install the wire harness clamp bracket with the bolt.
Torque:
8.4 N·m {86 kgf·cm, 74 in·lbf}
(b) Type A:
(1) Install the generator assembly with the 2 bolts.
Torque:
43 N·m {438 kgf·cm, 32 ft·lbf}
(2) Temporarily install the generator assembly bracket with the 2 bolts.
(3) Fully tighten the 2 bolts.
Torque:
20 N·m {204 kgf·cm, 15 ft·lbf}
(c) Type B:
(1) Install the generator assembly bracket to the generator assembly with the bolt.
Torque:
20 N·m {204 kgf·cm, 15 ft·lbf}
(2) Install the generator assembly with the 2 bolts.
Torque:
43 N·m {438 kgf·cm, 32 ft·lbf}
(3) Install the nut.
Torque:
20 N·m {204 kgf·cm, 15 ft·lbf}
(d) Engage the 2 wire harness clamps.
(e) Connect the magnetic clutch connector.
(f) Connect the generator assembly connector.
(g) Connect the wire harness to terminal B with the nut.
Torque:
12 N·m {122 kgf·cm, 9 ft·lbf}
(h) Close the terminal cap.
2. INSTALL V-RIBBED BELT
Click here
3. INSTALL RADIATOR ASSEMBLY
Click here
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
Inspection
ReassemblyLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Engine Assembly: Installation
INSTALLATION CAUTION / NOTICE / HINT CAUTION:
The engine assembly with transaxle is very heavy. Be sure to follow the procedure described in the repair manual, or the engine lifter may suddenly drop or the engine assembly with transaxle may fall off the engine lifter.
To prevent burns, do not t ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Wireless Door Lock Control System: Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Smart Access / Trouble Codes. Body Electrical > Smart Access > Trouble Codes (e) Check for DTCs. Click here CLE ...