TERMINALS OF ECU
STEERING WHEEL HEATER CONTROL ASSEMBLY
HINT:
Perform the inspection from the harness side with the connectors connected.
(a) Measure the voltage or resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| A-4 (IG) - Body ground | IG power supply | Engine switch on (IG) | 11 to 14 V |
| A-3 (SW) - Body ground | Steering heater switch (Integration control&panel assembly) input signal | Engine switch on (IG), Steering heater switch (Integration control&panel assembly) pressed and held | 11 to 14 V |
| A-2 (LED) - Body ground | LED output signal | Engine switch on (IG), Heated steering wheel system operating | Below 3 V |
| A-1 (GND) - Body ground | Ground | Always | Below 1 Ω |
| B-5 (SH1) - Body ground | Heater output signal | Engine switch on (IG), Heated steering wheel system operating | 11 to 14 V*1 |
| B-3 (TH1) - Body ground | Thermistor input signal | Engine switch on (IG), Heated steering wheel system operating on at 0 to 40°C (32 to 104°F) | 2.5 to 4.8 V*2 |
| B-2 (TH2) - Body ground | Thermistor ground | Engine switch on (IG), Heated steering wheel system operating | Below 1 V |
| B-1 (SH2) - Body ground | Heater ground | Engine switch on (IG), Heated steering wheel system operating | Below 1 V |
HINT:
System Diagram
Multiplex Tilt And Telescopic EcuLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Can Communication System: Check Bus 3 Lines for Short Circuit
DESCRIPTION There may be a short circuit between the bus 3 main lines and/or bus 3 branch lines when the resistance between terminals 6 (CA3H) and 21 (CA3L) of the network gateway ECU is below 54 Ω. Symptom Trouble Area Resistance between terminals 6 (CA3H) and 21 (CA3L) of network gateway ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Brake: Inspection
INSPECTION PROCEDURE 1. INSPECT PAD LINING THICKNESS (a) Using a ruler, measure the rear disc brake pad lining thickness. Standard Thickness: 9.5 mm (0.374 in.) Minimum Thickness: 1.0 mm (0.0394 in.) If a rear disc brake pad lining thickness is less than the minimum thickness, replace the rear ...